code replacement with PL posible?

January 19th, 2011, 02:51 PM

Hi,
Just a few simple questions.
1. Is there a way to tell MC to open at open and close at the same bar close? I don’t have smaller data for intrabarbacktesting.
2. Is there a way to sum code together that comes up every time? Something like:

Code

#xxxpla:
begin
         Print(“ this is good”);
         Print(“this is bad”);
         Buy this bar on close;
         var0=var0+1;
  End;

And everytime I use the key “xxxpla” the code from begin to end will replace that. something like define or replacement.
So I can write

Code

If condition0 then
            xxxpla;

xxxpla will be replaced from PL automaticaly. Is something like that possible?

January 20th, 2011, 03:27 PM

OK even when nobody wants to reply.
To Point no 1
I had to enter in the code from the Bar before the entrybar:

Code

if indi=1 and marketposition=0 then
        buy next bar at market;

and at the exitbar:

Code

if marketposition <>0 then
        sell this bar on close;

Probably to easy for you guys when you dont want to answer.

I still have the problem with the code replacement

code replacement with PL posible?

Discussion in EasyLanguage Programming

code replacement with PL posible?