Allows you to plot a Stochastic or a MACD from a different time frame on your chart. Typical use is to view a larger time frame Stochastic/MACD on a smaller (faster) chart....
(EX: Plot a 5min Stochastic on a 1min chart).
Also allows you to plot a Stochastic from a different BarType on your chart.
You can plot a RangeNoGap on a Tick Chart, or plot a Minute Stochastic on Tick Charts or Range charts....or vice versa. You can plot any accepted bartype Stochastic on any other accepted bartype chart.
Accepts standard Ninja Minute, Second, Tick, Range, and Volume bars.....and.....accepts BMT RangeNoGap Bars.
(NOTE: For those who do not have the RangeNoGap bars installed, you may get a warning message in the Ninja Log informing you that "Custom2 could not be found". In this case Ninja simply uses the default value of the indicator. Ninja will work quite fine....but if you have occasion to check your logs, it will let you know that you don't have that bartype installed.
CAUTION: if you plot a Stochastic from a very small/fast chart, on an extremely large/slow chart...the code will still work, but the "visual" effect will most likely not be helpful. The Stochastic from the fast time frame will go up and down so much that it will look like a fine tooth comb.....
CAUTION#2: "Stairsteps"..(visual flat spots on the plots lines)....can occur when plotting big time frames over smaller ones. This is not an error....simply a visual 'flat spot' where several smaller bars complete while the one larger time frame bar is still processing. There are ways to code around this, by holding values and plotting after the fact, but in the interest of code simplicity, I did not do that here. The 'flat spots" cause no errors or problems.
Category NinjaTrader 7 Indicators
|
|
|
View Download Details
